Des Moines Wood Floors: Wood Floor Refinishing in Beaverdale, IA

What pre-war Beaverdale floors usually need

Most houses in Beaverdale were built before 1950, and most of them still have their original floor. Usually red oak, usually 2¼ inch strip, and usually under a carpet somebody laid in 1974 and nobody has lifted since. That is good news: carpet protects wood, and the floor underneath is normally in better condition than the owner expects.

The question is never whether the floor is nice. It is how much wood sits above the tongue. Pull a floor register and look at the cut edge of the board, you need about 3/32 of an inch to sand safely. A 1920s floor that has been sanded twice may have one pass left, and knowing that before the machine starts is the difference between a floor restored and a floor finished off.

What we are asked for most here: hardwood floor refinishing, hardwood floor restoration, board replacement and weaving, refinish or replace?.

What we install in Beaverdale

Floor sanding

• Hardwood Floor Refinishing, sanding a floor back to bare wood and building a new finish on top
• Sand and Finish, the full three-pass sand and a fresh coat system
• Dustless Floor Sanding, sanding with the dust pulled straight off the drum instead of into your house
• Hardwood Floor Restoration, bringing a neglected or carpet-covered floor back into service

Refinishing

• Hardwood Floor Refinishing, sanding a floor back to bare wood and building a new finish on top
• Dustless Floor Sanding, sanding with the dust pulled straight off the drum instead of into your house
• Sand and Finish, the full three-pass sand and a fresh coat system
• Screen and Recoat, abrading the old finish and adding a coat without sanding to wood
• Hardwood Floor Restoration, bringing a neglected or carpet-covered floor back into service

Finishes and colour

• Hardwood Floor Staining, changing the colour of the wood before the finish goes on
• Water-Based Polyurethane Finish, the low-odour finish that dries clear and lets you back in sooner
• Oil-Based Polyurethane Finish, the amber-toned finish that wears longest and smells the most
• Hardwax Oil Finish, a penetrating finish you can spot-repair instead of resanding
• Matte, Satin or Gloss, how much sheen hides dust, scratches and Iowa winters

Repairs

• Hardwood Floor Repair, replacing damaged boards and blending them into the existing floor
• Board Replacement and Weaving, cutting out bad boards and weaving new ones in so the repair disappears
• Water-Damaged Floor Repair, drying, flattening and replacing what a leak or a flood lifted
• Squeaky Floor Repair, finding and fastening the movement that makes the noise
• Gap and Cupping Repair, diagnosing whether the movement is seasonal or a moisture fault
• Pet Stain and Scratch Repair, removing urine staining that has reached the wood, and refinishing over it

What it costs

• Hardwood Floor Refinishing Cost, what a sand and finish actually costs in this market, room by room
• Hardwood Floor Installation Cost, material plus labour, and what changes the number
• Cost to Refinish 1,000 Sq Ft, the whole-main-floor number most callers are trying to work out
• Cost for a 12x12 Room, the smallest job worth mobilising for, priced out
• Refinish or Replace?, how much wood is left above the tongue, and what that decides
• Engineered vs Solid Hardwood Cost, the price gap and where each one is the wrong choice
• LVP vs Hardwood Cost, what you give up for the lower number
• Stair Refinishing Cost Per Step, why stairs are priced by the step and not by the foot

What floor work costs in Beaverdale

These are the ranges we quote across Beaverdale and the rest of the Des Moines metro. Every number is per square foot, and every quote we write states the number of coats, the grit sequence and the finish system, so you can hold it next to another contractor's.

Those are the same rates we quote as wood flooring contractors in Des Moines, IA anywhere in the metro, the location does not change the price, the floor does. The one thing that moves an Iowa price more than any other is how much wood is left above the tongue, and we check that at a floor register before quoting, so the number you get is the number you pay rather than a change order on day two.

Permits in Polk County

Interior floor work needs no permit in Des Moines or any of the metro suburbs. What it does need is a moisture reading before anything is laid, and a written note of what that reading was, because when a floor cups two winters later, that number is the only thing that settles whether it was the wood, the subfloor or the basement.

Questions we get asked

How do I know if my floor can be refinished again?

Pull a floor register and look at the cut edge of the board. You need roughly 3/32 of an inch of wood above the tongue. Less than that and a full sand will expose the fasteners.

There is carpet over it, is the floor worth uncovering?

Almost always, in this part of the metro. Carpet protects wood from sunlight and grit. The floor underneath is usually in better shape than the strip you can see at a doorway.

Can you match a repair to a hundred-year-old floor?

Species and cut matter more than age. Quarter-sawn oak next to plain-sawn reads as a patch no matter how well it is finished, so we match the cut and weave the joints on a stagger.

Nearby areas

Elkhart · Alleman · Cumming · Berwick · Sherman Hill · Drake Neighborhood · South of Grand · Waveland Park

Get a quote in Beaverdale

Call . We come out, measure, talk through the finish, and leave a written price. No charge for the visit.